beautypg.com

Rivers Edge RE637 Spin Shot User Manual

Page 12

background image

Check for parts online at

www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5

12

Operator's Manual

Rivers Edge® Spin Shot™

SETUP AND USE INSTRUCTION CONTINUED

HOISTING YOUR SWIVEL SEAT

7. Using the three point contact climbing method, slowly descend the

ladder and carefully keep a constant hand grip on the ladder at all

times until you reach the ground.

8. Tie one end of your hoist rope (not included) to the seat assembly.

Be sure your double knot is secure. Place (4) 1/4-20 x 1-3/4” wing

bolts in your pocket.

9. With other end of hoist rope, use the three point contact climbing

method to slowly climb the ladder and carefully keep a constant

hand grip on the ladder at all times. Once you reach the platform,

immediately attach your harness tether to the tree. SEE FIGURE 17

10. Carefully raise the seat assembly to the platform using the hoist

rope (SEE FIGURE 16) and place seat post on top of the platform

and align the 4 holes in seat post plate to the 4 holes located in the

center of the platform. Remove (4) wing bolts from your pocket and

use them to secure the seat post/seat assembly to the platform.

Wing bolts should be inserted from the top and threaded into the

nut welds located on bottom side of platform. TIGHTEN SECURELY

BY HAND. SEE FIGURE 18

11. Reverse setup and use instructions to take ladder down.

hoist rope

seat

assembly

seat post

1/4-20 x 1-3/4" wing bolts

FIGURE 17

FIGURE 18