General Tools and Instruments PE-14 - Manual (Page 7)

• The camera head and its cover are waterproof, but not acid-
proof or fire-proof. Do not touch acidic, corrosive or hot
materials or they will ruin the camera head’s protective
plastic. Never place the camera head in contact with corrosive
or oily places or high temperature objects.
• When inspecting a vehicle, shut off the engine. Metal and
liquid under the hood may be hot. Don’t get oil or gas on the
camera head.
• Cover the camera-tipped end of the probe with the protective
rubber cap when not using it.
WARRANTY INFORMATION
General Tools & Instruments’ (General’s) PE14 Electrically
Insulated Probe for Seeker 400 Wireless Recording Video
Inspection Systems is warranted to the original purchaser to be
free from defects in material and workmanship for a period of
three years. Subject to certain restrictions, General will repair or
replace this product if, after examination, the company
determines it to be defective in material or workmanship.
This warranty does not apply to damages that General
determines to be from an attempted repair by non-authorized
personnel or misuse, alterations, normal wear and tear, or
accidental damage. The defective unit must be returned to
General Tools & Instruments or to a General-authorized service
center, freight prepaid and insured.
Acceptance of the exclusive repair and replacement remedies
described herein is a condition of the contract for purchase of
this product. In no event shall General be liable for any
incidental, special, consequential or punitive damages, or for
any cost, attorneys’ fees, expenses, or losses alleged to be a
consequence of any damage due to failure of, or defect in any
product including, but not limited to, any claims for loss of
profits.
7