General Tools and Instruments PE-14 - Manual (Page 5)

ATTACHING THE PROBE
To attach the PE14 probe to the handle (grip) of a DCS400
Series system, first roll the rubber insulation back from the
connector end of the probe. Then line up the probe’s alignment
key with the flat on the coupling of the DCS400’s probe
connector (left photo below). Push the two ends together until
they mate. To secure the connection, turn the collar of the probe
connector (right photo below). Finally, roll the yellow insulation
forward until it covers both joined metal connectors. Make sure
to extend the insulation until it reaches the grip's plastic
housing (bottom figure).
To detach the probe, reverse the process: After rolling back the
insulation, turn the collar counterclockwise and pull the PE14
straight out from the DCS400 probe connector.
USING THE PROBE
To use the probe, follow the operating instructions for the
DCS400 found in its user’s manual. Before using a DCS400
system with a PE14, read the Safety Instructions section of this
manual.
5