General Tools and Instruments DTH3007SD - Manual (Page 10)

SPECIFICATIONS
Embedded microcontroller Custom one-chip LSI device
Display type Liquid-crystal with green backlight
Display size 2.05 x 1.5 in. (52 x 38mm)
Parameters measured Temperature, relative humidity (R.H.), dew point,
wet-bulb temperature
Measurement range For temperature, 32º to 122ºF (0º to 50ºC); for R.H., 5 to 95%;
for dew point, -13.5º to 120.1ºF (-25.3º to 48.9ºC);
for wet-bulb temperature, -6.9º to 122ºF (-21.6º to 50ºC)
Measurement accuracy ± 1.5ºF (± 0.8ºC) for temperature; sum of temperature and
humidity accuracies for dew point and wet-bulb temperature
Measurement resolution 0.1 degree (F or C) for temperature and humidity
Sampling time options 0, 1, 2, 5, 10, 30, 60, 120, 300, 600, 1800 or 3600 seconds
(0 seconds to 1 hour)
Settable parameters Date, time, auto power off, beep sound, sampling time,
decimal point or comma decimal division, temperature unit
Storable/recallable readings Maximum, minimum
SD card capacity 1 GB to 16 GB
Operating temperature 32º to 122ºF (0º to 50ºC)
Operating relative humidity 0 to 85%
Power source 6 Alkaline “AA” batteries or optional 9-VDC AC adapter
Power consumption 3.5 mADC (normal operation, with backlight off and SD card
not saving data); 28 mADC with backlight on and card saving
data; 40 mADC with backlight on and card saving data
Dimensions of meter 6.97 x 2.68 x 1.77 in. (177 x 68 x 45mm)
Weight of meter 1.08 lb. (489g)
MAINTENANCE & TROUBLESHOOTING TIPS
When the icon appears in the left corner of the display, it’s time to replace the six
“AA” batteries that power the instrument (although measurements will remain valid for
several hours after the low-battery indicator first appears). Replacing the batteries requires
removing the two screws that hold the battery compartment cover in place, as explained in
Step 1 of the setup procedure. After inserting fresh batteries in the correct orientation,
tighten the screws to secure the cover.
10