General Tools and Instruments DT4947SD - Manual (Page 13)

13
MAINTENANCE TIPS
Keep your probes and thermocouples clean.
When the icon appears in the left corner of the display, it’s time to replace the six
“AA” batteries that power the thermometer (although measurements will remain valid for
several hours after the low-battery indicator first appears). Replacing the batteries requires
removing the two screws that hold the battery compartment cover in place, as explained in
Step 1 of the setup procedure on page 6. After inserting fresh batteries in the correct
orientation, tighten the screws to secure the cover.
Remove the batteries when storing the thermometer for an extended period of time.
Do not drop or disassemble the thermometer or immerse it in water.
OPTIONAL ACCESSORIES
Optional accessories available from General Tools & Instruments include:
• Pt 100 ohm resistance-temperature detector (RTD) probes
• Types K, J, T, E, R and S thermocouple thermometers
• 9VDC adapter for a 110V power supply
WARRANTY INFORMATION
General Tools & Instruments’ (General’s) DT4947SD 4-Channel Thermometer with
Datalogging SD Card is warranted to the original purchaser to be free from defects in
material and workmanship. Subject to certain restrictions, General will repair or replace this
instrument if, after examination, the company determines it to be defective in material or
workmanship for a period of one year.
This warranty does not apply to damages that General determines to be from an attempted
repair by non-authorized personnel or misuse, alterations, normal wear and tear, or
accidental damage. The defective unit must be returned to General Tools & Instruments or
to a General-authorized service center, freight prepaid and insured.
Acceptance of the exclusive repair and replacement remedies described herein is a
condition of the contract for purchase of this product. In no event shall General be liable for
any incidental, special, consequential or punitive damages, or for any cost, attorneys’ fees,
expenses, or losses alleged to be a consequence of any damage due to failure of, or defect
in any product including, but not limited to, any claims for loss of profits.