General Tools and Instruments DCS300 - Manual (Page 9)

9
the camera head into corrosive, oily places or high
temperature objects.
5. Don’t place the cameral head or probe into anything or
anywhere that may contain a live electrical charge.
Please check following methods to avoid injury.
For walls: For inspecting the inside walls, be sure to shut off
the circuit breaker to the whole house before
using the tool.
For pipes: If you suspect a metal pipe could contain an
electrical charge, have a qualified electrician
to check the pipe before using. A ground circuit,
in some cases, can be returned to the cast
aluminum pipes and cause them to be charged.
For automobiles: Be sure the automobile is not running during
inspection. Metal and liquid under the hood may
be hot. Don’t get oil or gas on the camera head.
• Please do not operate this product unless the manual
has been read thoroughly and proper training has been
completed.
• Do not immerse the handheld display unit in water which
will result in electric shock and damages.
• The camera head is water-proof, but the handheld display
is not water-proof.
• Do not use the product if condensation forms inside
the camera head.
• If the tool does not work well after turning it on. Please
take the batteries out and do not use. Please have the
unit checked by a qualified technician.
• Store idle products out of reach of children and other
untrained personnel. The product is dangerous in the
hands of untrained users.
• Maintain the inspection product with care. If the product
DCS200-300 MANUAL 071609 FINAL:Manual 7/16/09 1:25 PM Page 9