General Tools and Instruments DCS300 - Manual (Page 7)

7
CONNECTING THE DISPLAY UNIT TO THE CAMERA
HEAD AND PROBE:
The display unit must be connected to the cameral head and
probe. To connect the probe to the display unit, make sure the
keyed ends are properly aligned (See Fig. 6). Once they are
aligned, tighten the nut.
ACCESSORIES INSTALLATION:
The three accessories include mirror tip, hook tip and
magnetic tip (See Fig. 2). All are attached to the camera
head the same way. Hold the camera head as shown in Fig. 7,
slip the semicircle end of the accessory over the flats of the
camera head and then rotate the accessory 90° to fix
as shown in Fig. 8.
DCS200-300 MANUAL 071609 FINAL:Manual 7/16/09 1:25 PM Page 7