General Pump LK Repair Manual - Manual (Page 8)

GENERAL PUMP
A member of the Interpump Group
LK SERIES
Unscrew the connecting rod screws (pos.1, fig. 17).
Dismantle the small ends of the connecting rods with the half-bearings. During the operation take particular
care to note the order in which the parts are removed
The connecting rod small ends and the big end halves must be reassembled in exactly the
same order and pairings in which they were dismantled.
To prevent any errors, small ends and big end halves are numbered on one side (pos. 1, fig. 18).
Advance the three big end halves as far as possible in the direction of the head. Slip off the three upper half-
bearings of the beg end halves (pos. 1, fig 19).
Page 8