General Pump LK Repair Manual - Manual (Page 23)

GENERAL PUMP
A member of the Interpump Group
LK SERIES
Page 23
Insert the pressure bushing completely onto the crankshaft (pos. 1, fig. 76 and fig. 77) using a mallet or
striking hammer and a pad.
Fasten the bearing support covers with 6 M10X30 screws (pos. 1, fig. 74). Tighten the screws with a torque
wrench, as shown in section 3. “Screw Tightening Settings”.
Partly insert the two pressure bushings, keeping the crankshaft lifted up by means of the previously mounted
M16 pin (pos. 1, fig. 75).