Finish Thompson S6 - Manual (Page 7)

7
Noise Level
S6 Rechargeable Motor in normal operating conditions produces a sound level equal to or less than 64 dBA at a distance of three
feet (~ one meter).
Modifications and Spare Parts
Any changes concerning the service of the motor as originally purchased can be executed only after written approval from Finish
Thompson, Inc. It is recommended to use only genuine Finish Thompson, Inc. spare parts and approved accessories. The use of
non-original spare parts or non-approved accessories will void warranty and removes any responsibility on our behalf for any dam-
age caused to people or things.
1. Unpack motor and pump tube from carton. Check for shipping damage. If damage is detected, save the packaging and notify the
carrier immediately.
2. If motor and pump tube are boxed separately, the motor will need to be fastened to the pump tube. See figure 1.
3. Place the motor upside down on a tabletop surface with the coupling facing upwards and place the yellow coupling insert (item 1)
from the pump manual onto the motor’s coupling. See figure 2.
4. Position the pump tube upside down onto the motor. Align the discharge spout of the pump facing away from the handle of the
motor. See figure 3.
5. Firmly press the pump tube onto the motor until it lays flat. A slight twist may be necessary for the coupling splines to line up
properly. See figure 4.
6. Align the 4 bolt holes in the pump to the 4 holes in the motor, and fasten with 4 pieces (item 7) flat washer and 4 pieces # 8
Screw (item 8) from the pump manual using a # 2 Philips head screwdriver. Note: The EFS (316SS) model does not use the 4
pieces of (item 7) flat washers. Hand-tighten, being careful not to over-torque and strip the plastic.
See figure 5.
7. Using a SS hose clamp, secure a ¾” ID chemically compatible reinforced hose to the discharge spout of the pump.
INSTALLATION
Figure 5
Figure 1 Figure 2 Figure 3
Figure 4