Farm Star T55-74 - Manual (Page 33)

11 32
S A F E T Y I N S T R U C T I O N S (continued) M O D E L T 2 5 G E A R B O X
PA RTS VIEW & PA RTS LIST
Stop tiller and tractor immediately upon striking an obstruction. Turn engine off, remove key, inspect and repair
any damage before resuming operation.
Use extreme care and maintain minimum ground speed when transporting on hillside, over rough ground and
when operating close to ditches or fences. Be careful when turning sharp corners.
Inspect the entire machine periodically as indicated in the Maintenance Section of this manual. Look for loose
fasteners, worn or broken parts, and worn PTO driveline joints and/or shields. Make sure all pins have cotter
pins and washers. Serious injury may occur from not maintaining this machine in good working order.
Avoid sudden starts and stops while traveling up or downhill.
Always cut down slopes; never across the face. Avoid operation on steep slopes. Slow down on sharp turns
and slopes to prevent tipping and/or loss of control. Avoid slopes when surface is wet, slippery grass or soil.
Never attempt to check or adjust chain tension while implement is operating. Always stop it before this
operation.
If tiller become clogged, shut off engine, disengage PTO, and set brake or place in park before cleaning.
Never operate tiller in fully raised transport position. Disengage the PTO when raised for transport or backing
up. The tractor’s 3 point hitch lift height should be adjusted so that the tiller tines are not more than 14 inches
off the ground to prevent damage to the PTO driveline joints. PTO driveline joints cannot operate at sharp
angles.
OPERATIONAL SAFETY (continued)
Do not allow riders on the rotary tiller or tractor at any time. There is no safe place for any riders.
Disengage power takeoff (PTO) and place transmission into neutral before attempting to start engine.
Install and secure all guards and shields before starting or operating.
Keep hands, feet, hair, and clothing away from moving parts.
This rotary tiller is designed for use only on tractors with 540 RPM power takeoff.
Pick up all rocks and other debris before tilling. Enter new areas carefully. Never assume an area is clear.
Always Check!