Farm Star XHB-1120 User Manual
Owner’s manual, 3 pt. rear blade
OWNER’S
MANUAL
MODEL NO.’s
XHB-1096
XHB-1120
CAUTION
For Safe Operation
Read Rules And
Instructions Carefully
S A F E T Y P R E C A U T I O N S
MOST ACCIDENTS OCCUR BECAUSE OF NEGLECT OR CARELESSNESS.
AVOID NEEDLESS ACCIDENTS BY FOLLOWING ALL OF THE SAFETY PRECAUTIONS LISTED BELOW.
•
Machinery should be operated only by those who
are responsible and are authorized to do so.
•
Stop the engine, lower all equipment, lock the
brakes, and remove the ignition key before dis-
mounting from the tractor.
•
Never stand between tractor and implement while
tractor is being backed to hitch.
•
Loose fitting clothing should not be worn, to avoid
catching on various parts.
•
Detach implement in area where children normally
do not play.
•
When performing adjustments or maintenance on
an implement, first lower it to the ground or block it
securely at a workable height.
•
Only a qualified operator should be permitted on
tractor when in operation; no riders allowed.
•
Make certain everyone is in the clear before starting
tractor or raising or lowering equipment.
•
Operate the tractor and implement only while
seated in the driver’s seat.
•
Reduce speed when transporting mounted
implements to avoid bouncing and momentary loss
of steering control.
•
A heavy load can cause instability of the tractor.
Use extreme care during road travel. Slow down on
turns and watch out for bumps. Tractor may need
front counter-weights to counter-balance the weight
of the implement.
•
Reduce speed on hillsides or curves so there is no
danger of tipping.
•
Avoid driving too close to the edge of ditches or
creeks.
•
Do not transport implement on public roads without
reflectors and slow moving vehicle emblem in
daylight and with approved warning lights at night
and other periods of poor visibility.
•
Due to the width of some implements, use extra
caution on highways, farm roads, and when
approaching gates.
•
Always be sure the implement is in the proper
position for transport.
•
Keep alert and watch the front as well as the rear
when working with the implement.
OWNER’S
MANUAL
MODEL NO.’s
XHB-1096
XHB-1120
WHEN ORDERING
REPAIR PARTS,
ALWAYS GIVE
THE FOLLOWING
INFORMATION:
1. PART NUMBER
2. PART DESCRIPTION
3. MODEL NUMBER
4. NAME OF ITEM
APRIL 1998
WS-RB006-OG
W O R K S AVER, INC.
P.O. BOX 100 LITCHFIELD, IL 62056-0100 (217) 324-5973
WEB: http:// www.worksaver.com E-MAIL: [email protected]
MAKE EVERY DAY
A HOLIDAY
FROM ACCIDENTS
3 PT. REAR BLADE
For Cat. II
3 Pt. Hitch Tractors
Safety Instructions
Assembly & Mounting
Tractor Preparation
Maintenance
Operating Instructions
Repair Parts
C A U T I O N
THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE THOROUGHLY UNDERSTOOD
BEFORE ATTEMPTING TO BEGIN ASSEMBLING THIS MACHINE
1. Select an area for assembly that is clean and free
of any debris which might cause persons working
on the assembly to trip.
2. Do not lift heavy parts or assemblies. Use crane,
jack, tackle, fork trucks or other mechanical devices.
3. Preview the assembly instructions in your operator’s
manual before proceeding further.
4. If the assembly instructions call for parts or assem-
blies to be blocked up, use only blocking material
that is in good condition and is capable of handling
the weight of the assembly to be blocked. Also
insure that the blocking material is on a clean, dry
surface.
5. Never put hands, or any part of body, under blocked
up assemblies if at all possible.
6. After completing assembly, thoroughly inspect the
machine to be sure that all nuts, bolts, hydraulic
fittings or any other fastened assemblies have been
thoroughly tightened.
7. Before operating the machine, thoroughly read the
operation section of your operator’s manual.
8. Before operating, read the maintenance section of
your operator’s manual to be sure that any parts
requiring lubrication, such as gearboxes, are full,
to avoid any possible damage.
9. Before operating equipment – If you have any
questions regarding the proper assembly or
operation, contact your dealer or the manufac-
turer
STATEMENT
OF POLICY
It is the policy of Farm Star
to improve its products
where it is possible and prac-
tical to do so. Farm Star
reserves the right to make
changes or improvements in
design and construction at
any time, without incurring
the obligation to make these
changes on previously manu-
factured units.
3 PT. REAR BLADE
For Cat. II
3 Pt. Hitch Tractors