Fairbanks Tundra Series Truck Scale - Manual (Page 17)

Section 3: Pre-Installation
12/12 17 51193 Revision 5
3.3.1. Physical Installation Notes
• Before installation, check that all components are in good condition.
─ If damage occurs due to shipping, order the new part or component
immediately.
• Only those charges which are incurred as a result of the equipment's
inability to be adjusted to performance specifications may be charged to
warranty.
• No physical alterations (mounting holes, etc.) are allowed during installation.
IMPORTANT NOTE: The installing technician is responsible that all personnel
are fully trained and familiar with the equipment's capabilities and limitations before
the installation is considered complete.
3.4. TOOLS, EQUIPMENT AND MATERIALS
The following tools, equipment and materials are suggested to be on hand
before the installation begins.

Certified Project Drawing Specifications
3.4.1. Measuring, Testing & Checking
Equipment
• Surveyor's Transit and Rod
• Plumb Bob
• Stringline and a chalkline
• 50 to100' steel tape measure.
• Machinist’s Levels ( Starrett #134 & 132-6 )
• Carpenter's Level
• Multimeter