Fairbanks HVX Series TALON SERIES Motor Truck Scale - Manual (Page 17)

8. Base Plate Completion:
• Check that all locating tools are properly aligned and flush with the receiver
cups. Drill the holes for the outside base plate anchors using a hammer drill
and the
5 /
8
" drill bit. Tap the anchors into clean holes and tighten the nuts
securely.
9. Installing Load Cells:
a. Unpack the load cells and mark each calibration certificate with the load cell
location/position.
b. Starting at one end of the assembled platform, place hydraulic jacks at the
corners so the section can be lifted off the locating tool. (Two (2) hydraulic
jacks may be required).
c. Lift the platform so the load cell locating tool can be removed from the upper
and lower bearing cups. Once removed, fill both cups with grease.
50785 17 04/12 Rev. 5
50785-2
CHECK BRACKET
PART # 75398
1 1/8” BOLT, 8” LG.
PART # 75698
1” BOLT, 6 1/2” LG.
PART # 60312
1 3/8”
3 1/2”
~Caution~
Use eye protection!