Fairbanks HVX Series TALON SERIES Motor Truck Scale - Manual (Page 16)

6. Connecting the Modules:
• Bolt the modules together using the 1- 1 / 8 " x 7" full-thread rod, lock washer, flat
washers
and nut provided. Remember to shim the supporting blocks if necessary to
align modules. Snug nuts, but do not fully tighten them yet
(see Figure 50785-1).
7. Checking Adjustment (see Figure 50785-2).
a. Adjust End Checking
• Adjust the End Checking Bolts so that they touch and prevent movement.
b. Install the side checking brackets:
•
Bolt the brackets to the end checking plates embedded in the end walls per
Certified prints. Set the bolts so that they touch the block they bump
against.
50785 16 04/12 Rev. 5
50785-1
1 1/8”-7 THREADED ROD
W/NUT & WASHERS
PART # 76708
* * Warning * *
Module-to-module bolts MUST be installed correctly and torqued properly after all lifting,
etc. is completed. Do NOT substitute or omit bolts.