Fairbanks HVX Series TALON SERIES Motor Truck Scale - Manual (Page 11)

A. Introduction
Installation consists of the following:
• Foundation check, layout, and base plate setting
• Tools, materials, documentation, and a crane
• Setting the modules
• Setting the modules on load cells
B. Preparations for Installations, all Models
1. Tools, Equipment, and Materials Required:
a. Certified Prints
b. A mobile crane of sufficient capacity to safely lift and place the weigh bridge
modules.
Approximate maximum weights:
• Steel modules - 4 tons
• Field pour Modules - 2.5 tons
w/concrete - 12.5 tons to 15 tons +/- 5%
c. Four (4) equal length (20 ft) lifting chains or cables with hooks to safely attach
to the modules at the lifting points.
d. Machinists levels (starrett # 134 & 132-6)
e. Hand tools
f. Hammer Drill with 5 /
8
" bit, 24" long
50785 11 04/12 Rev. 5
Section 2: Installation
Note: The lifting chains or cables MUST be requested in advance from the crane vendor.
Note: Additional installation instructions are provided for the Field-Pour deck in Section 3
of this manual.