Fairbanks HVX Series TALON SERIES Motor Truck Scale - Manual (Page 15)

c. Measure from each side of each end of the module, to the end walls, to be
certain the module is plumb and square before removing tension.
d. Once the tension on the lift cables is released, remove the lift cables.
5. Setting End Modules
a. Module Placement
•
Guide the modules into place with the supporting blocks on the end of the
module coming to rest on the supporting blocks of the center module.
Lower the other end of the module onto the load cell locating tools or
blocks. (see Figure 50518-24).
b. Before releasing tension on the cables, check the alignment of the end modules
to the center module and to the end wall.
• Use the provided shims to set height and fill any gaps on the supporting
blocks to get the modules aligned.
c. Repeat this process for the other end of the module or for the Interior Module.
50785 15 04/12 Rev. 5
50518-24