Fairbanks 1100 Series Portable Utility Scale with Rechargeable battery-powered FB1100 ABS - Manual (Page 10)

Section 4: Assembly
02/2011 10 51260 -- Rev. 1
Section 4: Assembly
C A U T I O N
The scale base assembly, as shipped, weighs 185 pounds.
USE CAUTION WHEN LIFTING.
NOTE: The descriptions below refer to the item numbers used in the parts list in
Section 7. Use the parts list and item numbers to identify the parts below.
4.1. Wheel and pillar assembly
A. Set the scale base assembly (#4) upright on the floor.
B. Starting with an axle (#19), insert a cotter pin (#17) in one end, then place a
washer (#18) and a wheel (#16) over the open end.
C. Insert the axle’s other end through BOTH holes in the base.
D. Place a wheel (#16), then a washer, over the other end and insert a cotter pin.
E. Repeat steps B, C, and D for the second axle.
F. “Center” the axles in the base, then insert the locking screws (#15) into the
tapped holes in the bottom of the base directly under the axle holes.
G. Tighten the locking screws, then secure the lock nuts (#14).
H. Screw the two (2) pillar rods (#1) into the base in the two (2) tapped holes
provided.
I. Place the pillar (#2) over the pillar rods with the cutouts facing to the left and
right of the platform.
J. Insert the steelyard rod (#35) down through the pillar with the bent hook on top
and the loose swivel hook on the bottom.