FEC AFC1500 - Manual (Page 2)

AFC1500 Multi-2 Unit Hardware Manual (Rev. 2)
PAGE 4 - 2
Chapter 4: Installation & Wiring
4.1 Installation
Multi-2 Units must be mounted with a minimum clearance of 13mm on each side to allow proper heat
dissipation. Cable connections on the front of the units require 100mm of clearance. Allow a minimum
of 100mm clearance on the bottom of the unit for flash connector hook up when updating firmware.
The Multi-2 Unit should be mounted into a NEMA12 / IP52 enclosure at a minimum and spaced similar
to the AFC1500 SAN Units (typical installation example shown below).
(See Section 2.2 for Unit Dimensions)