FEC AFC1500 - Manual (Page 12)

AFC1500 Multi-2 Unit Hardware Manual (Rev. 2)
PAGE 4 - 12
Chapter 4: Installation & Wiring
4.6.4 DATA-OUT 2 Port
“DATA-OUT2” port is currently not used.
RS-232 Pin Layout (Male)
1 DCD
2 RXD
3 TXD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 Not Used
Note: This port is removed when using the Ethernet Version (Optional ¡ ¡ ¡ ¡ E ¢ ¢ ¢ ¢ Version) Multi
Unit
4.6.5 DATA-IN Port
The “DATA-IN” port is for inputting ASCII data to the fastening system for marriage to the fastening
data. It is typically used for attaching part serial number(s) to the fastening data for data storage
birth history.
RS-232 Pin Layout (Male)
1 DCD
2 RXD
3 TXD
4 DTR
5 GND
6 Not Used
7 RTS
8 CTS
9 Not Used
RS-232C DATA-IN CABLE
* When using the DATA-IN port, PIN 1 (DCD) must be enabled for data input (Jumper pins 1 & 4).
Front View
Front View