Teledyne 9070 - O2 and CO2 Food package analyzer (preliminary) - Manual (Page 9)

Indication Choice, Lower Line
Any or all of the following can be selected for lower line display:
Options:
• Oxygen Sensor EMF
• Oxygen Sensor Temperature
• Oxygen Sensor Impedance
• Sample Oxygen/Carbon Dioxide
• Ambient Temperature
• Ambient relative humidity
• Balance gas (Remaining gas after the O2 and CO2 have been subtracted)
• Date - time
• Run Hours since last service
• Date of last service
Relay Contacts
0.5A 24 VAC, 1A 36 VDC •
Mounting
• Desk top. Also available as a surface mount Analyzer with an external oxygen sensor.
1.3 ORDERING INFORMATION
Orders may be placed by submitting the following information (please number each item as below):
1. State if carbon dioxide measurement is required.
2. Minimum and maximum expected oxygen in sample (particularly the minimum value)
3. Other gas constituents (Any combustibles will consume oxygen as they are burnt on the surface of
the sensor)
4. If the gas is under pressure or if the gas must be extracted to the 9070 Analyzer.
5. Gas connection required (1/8’’ Swagelok is standard)
6. Supply voltage (240 or 110 VAC)
7. If auto/manual on-line oxygen gas calibration checking is required.
8. If surface mounting of the instrument is required or if free standing on
rubber feet is preferred.
Ask your local Teledyne Analytical InstrumentsDistributor for assistance in ordering
1.4 MODEL SELECTION GUIDE
There are 3 options/models available within the 9070 range.
9070-1 Oxygen sensor only, with pump.
9070-2 Oxygen sensor only, no pump.
9070-5 Oxygen sensor and carbon dioxide sensor, with pump.
Teledyne Analytical Instruments 9070 Oxygen Analyzer Page 9