Bosch TES50621RW VeroCafe LattePro Machine à café Expresso automatique Titanium - Manual (Page 12)

8
Robert Bosch Hausgeräte GmbH
en
11. Select the required display language
with the upper rotary knob (15). The
following languages are available:
English Nederlands
Français Italiano
Svenska Español
Polski Magyar
Türkçe Dansk
Norsk Suomi
Português Čeština
ελληνικα български
русский
12. Place a receptacle under outlet (6a).
13. Press the start button (10).
The language you selected is saved.
The appliance heats up and rinses. Some
water will run out of the coffee outlet.
When the drink selection menu is shown in
the display, the appliance is ready for use.
Switching off the appliance
The factory settings of the fully automatic
espresso machine are programmed for opti-
mal performance. The appliance switches
off automatically after a specific time (time
span can be programmed, see “Menu set-
tings” Shut off ).
Exception: The appliance switches off
without rinsing if only hot water or steam
were dispensed.
To switch the appliance off manually before
this, press the
e
off / j button (13). The
appliance rinses and switches off.
N.B.: If the appliance is being used for the
first time, a service program has been run,
or the appliance has not been operated for a
long period, the first beverage will not have
the full aroma and should not be consumed.
When using the espresso machine for the
first time, you will achieve a suitably thick
and stable “crema” only after the first few
cups have been dispensed.
After extended use, water droplets may
form on the ventilation slots. This is normal.
Water filter
A water filter can prevent scale buildup.
Before a new water filter is used, it must be
rinsed. To do this, proceed as follows:
1. Press the water filter firmly into the
water tank with the aid of the measuring
spoon (19).
2. Fill the water tank (17) with water up to
the max mark.
3. Press and hold the
e
off / j button (13)
for at least three seconds. The menu
opens.
4. Press the
e
off / j button (13) repeat-
edly until the display shows No / Old
filter .
5. Select Activate filter with the upper
rotary knob (15).
6. Press the start button (10).
7. Place a receptacle with a capacity of
0.5 litres under the outlet (6a).
8. Press the start button (10).
9. Water will now flow through the filter to
rinse it.
10. Empty the container.
The appliance is ready to use once more.
Note: Rinsing the filter simultaneously
activates the setting for the Change filter!
display.