Hardware setup – Asus CUPLE-VM JumperFree PC133 User Manual
Page 34
34
ASUS CUPLE-VM User’s Manual
Connectors
3. H/W SETUP
3. HARDWARE SETUP
19) System Warning Speaker Connector (4-pin SPEAKER)
This 4-pin connector connects to the case-mounted speaker. Two sources
(LINE_OUT and SPEAKER) will allow you to hear system beeps and warn-
ings. Only SPEAKER will allow you to hear system beeps before the integrated
audio has been properly initialized.
20) System Power LED Lead (3-1 pin PWRLED)
This 3-1 pin connector connects the system power LED, which lights when the
system is powered on and blinks when it is in sleep mode.
21) Reset Switch Lead (2-pin RESET)
This 2-pin connector connects to the case-mounted reset switch for rebooting
your computer without having to turn off your power switch. This is a preferred
method of rebooting to prolong the life of the system’s power supply.
22) ATX Power Switch Lead (2-pin PWRSW)
The system power is controlled by a momentary switch connected to this lead.
Pressing the button once will switch the system between ON and SOFT OFF.
Pushing the switch while in the ON mode for more than 4 seconds will turn the
system off. The system power LED shows the status of the system’s power.
The following 20-pin PANEL illustration is for items 19-22:
CUPLE-VM
CUPLE-VM System Panel Connectors
*
Requires an ATX power supply.
PLED-
PWR
PLED+
+5V
Speaker
Speaker
Connector
Power LED
Ground
Reset SW
GND
Reset
Ground
Ground
ATX Power Switch*