beautypg.com

Hardware setup, Asus cuple-vm user’s manual 33 – Asus CUPLE-VM JumperFree PC133 User Manual

Page 33

background image

ASUS CUPLE-VM User’s Manual

33

3. HARDWARE SETUP

Connectors

3. H/W SETUP

17) ATX Power Supply Connector (20-pin block ATXPWR)

This connector connects to an ATX power supply. The plug from the power sup-
ply will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.

IMPORTANT:

Make sure that your ATX power supply can supply at least 10mA

on the +5-volt standby lead (+5VSB). You may experience difficulty in power-
ing ON your system if your power supply cannot support the load. For Wake-
On-LAN support, your ATX power supply must supply at least 720mA +5VSB.

18) IDE Activity LED (2-pin IDELED)

This connector supplies power to the cabinet’s IDE activity LED. Read and
write activity by devices connected to the Primary/Secondary IDE and Primary/
Secondary ATA100 connectors will cause the LED to light up.

CUPLE-VM IDE Activity LED

TIP: If the case-mounted LED does not
light, try reversing the 2-pin plug.

IDELED

CUPLE-VM

CUPLE-VM

CUPLE-VM ATX Power Connector

+3.3 V

olts

-12.0 V

olts

Ground

Power Supply On

Ground

Ground

Ground

-5.0 V

olts

+5.0 V

olts

+5.0 V

olts

Power Good

+12.0 V

olts

+3.3 V

olts

+3.3 V

olts

Ground

+5.0 V

olts

Ground

+5.0 V

olts

Ground

+5V Standby

This manual is related to the following products: