Asus Terminator 2 Barebone System T2-R - Manual (Page 79)

79 ASUS Terminator 2 barebone system
12. System panel connector (8-1 pin PANEL)
This connector accommodates several system front panel functions.
P4R8T ®
P4R8T System Panel Connector
* Requires an ATX power supply.
PLED+
PWR
Power LED
Ground
ATX Power
Switch*
PLED– IDE_LED+ IDE_LED–
IDE_LED
PANEL
• Power LED Lead
This 2-pin connector connects to the system power LED. The LED
lights up when you turn on the system power, and blinks when the
system is in sleep mode.
• ATX Power Switch
This connector connects a switch that controls the system power.
Pressing the power switch turns the system between ON and SLEEP,
or ON and SOFT OFF, depending on the BIOS or OS settings.
Pressing the power switch while in the ON mode for more than four
seconds turns the system OFF.
11. USB card reader connector (10-1 pin USB56)
This connector supports the storage card reader. Connect one end of
the storage card reader cable to pins 1-5 of this connector, as shown.
P4R8T ®
USB56
1 5
6 10
GND USBP3+ USBP3- USB Power
NC
GND
USBP2+ USBP2-
USB Power P4R8T USB Card Reader Connector