Asus Terminator 2 Barebone System T2-R - Manual (Page 33)

33 ASUS Terminator 2 barebone system
2.8 Installing a second optical drive
The Terminator 2 system comes with two 5.25-inch drive bays for two
optical drives. If your system came with a pre-installed optical drive, refer
to this section when installing a second optical drive.
To install a second optical drive:
1. Place the chassis upright.
2. Locate the front panel cover
hooks.
3. Press the hooks inward to
release the front panel cover
from the chassis.
4. Detach the front panel cover top
hooks.
5. Push the the front panel cover
slightly outwards, then set it aside.
1
2
3
On Deluxe models, disconnect
the LED panel and the front
audio button panel cables from
their respective connectors
before removing the front panel
cover.
Set your second optical drive as Slave device before connecting the
IDE cable and power plug. Refer to the optical drive documentation on
how to set the drive as a Slave device.
3
3
3
4
4
6. Carefully push the optical drive
into the bay until its screw holes
align with the holes on the bay
as shown.
7. Secure the optical drive with two
screws on one side of the bay.
6 7
5