PSA PIN388D/PIN388L User Manual - Manual (Page 6)

PINKERTON Quick Setup
4
To DISARM the panel:
(a)
On Keypad
Enter:
(Clears the keypad)
Enter: (All Zone lights will flash)
(b)
Followed by: (The OFF key)
Step 8: Walk Test
To check operation of all Zones a Walk Test is recommended.
(a) On Keypad
Enter:
(Clears the keypad)
Enter: (All Zone lights will flash)
(b) Followed by: (To initiate a walk test)
The walk test function is now activated.
The Zone LED will light as each Zone is triggered and the siren will squawk momentarily. The
Zone LEDs will remain on to show which Zone has been violated. (Requires only one person
testing).
To deactivate a walk test press the
key.
THE SYSTEM IS NOW OPERATIONAL
To arm and disarm the system enter
followed by the Master User Code
(factory default) followed by
To arm the system enter: (ON)
To disarm the system enter: (OFF)
Note: The system can also be quick armed by pressing
To disarm enter User Code then
To change Master User Code or User Codes, please refer to Page 22
This completes the instruction for a Local Panel