PSA PIN388D/PIN388L User Manual - Manual (Page 27)

PINKERTON User Manual
25
Programming Telephone Numbers
Note: To be able to program telephone numbers the PINKERTON
alarm must be programmed for personal dialling format.
Telephone numbers are programmed at specific addresses in the
system memory.
Addresses are:
Telephone Number 1 128
Telephone Number 2 144
Temporary Telephone 112
Programming Telephone number 1
1. Enter .............................. To clear the keypad
2.
BBBB
........................ Your Master Code
(All Zone lights will flash - waiting for a command)
3. ........................................ To enter program mode
(ON-LINE lights flashing indicates program mode)
4. .............................. Address for Telephone number 1
(The existing telephone number, if any, will be displayed digit by digit)
5.
BBBBBBBB
..... Enter the Telephone number
(Maximum 15 digits)
(If you make a mistake at this stage, press to go back to step 3)
6. ................................... Must be entered after the number
7. ........................................ To finish current address
At this stage you can enter the address of another telephone
number by repeating steps 3 to 6 or press to exit program mode.
Note: The maximum length of any telephone number is 15 digits.