PSA PIN388D/PIN388L User Manual User Manual

Page 14

PINKERTON User Manual

PINKERTON Operation

Keypad Key Functions

After a code is entered or the

key is

pressed, you have 10 seconds to select the
operation you wish to perform. During this
time all 8 Zone lights will flash to indicate
that a key should be pressed. If no key is
pressed within 10 seconds, the keypad will
revert to idle mode. Enter your code to start
again.

The

key is always used as the "clear key" to abort the current operation.

Operation of all keys

PANIC

Key

Enter a User Code followed by

or enter

to trigger the Panic

function. The Panic function can trigger the siren or strobe light or dialler
as programmed by your installer.

DURESS

Key

Enter a User Code followed by

or enter

to trigger the Duress

function. The Duress function can trigger the siren or strobe light or dialler
as programmed by your installer.

TEST

Key

Enter a User Code followed by

or enter

to trigger the Test

function. The Test function is used to test the dialler by sending a test
transmission to the programmed telephone numbers. This function is only
available if your system is programmed to report alarms to a monitoring
station.