PSA PIN388D/PIN388L User Manual - Manual (Page 13)

PINKERTON User Manual
11
Keypad Beeper Operation
The keypad beeper will sound under the following circumstances:
Any key press short beep
Turn Alarm system OFF short beep
Turn Alarm system ON (only heard if exit beep is
disabled) 2 short beeps
Display of new data in programming mode 2 short beeps
Wrong key or illegal action long beep
Press key long beep
In Home Mode when a Home Beep Zone is triggered short beep
Keypad lockout due to too many code entry attempts continuous beep
During exit delay if Exit Beep is enabled continuous beep
At end of exit delay if Exit Beep is disabled 3 short beeps
During entry delay if Entry Beep is enabled continuous beep
Keypad Lockout
If an incorrect code is entered 4 times then the keypad will be locked out
for 60 seconds. During this time the Zone lights will be on and the beeper
will sound continuously.
Keypad Entry Errors
When an error is made in entering digits, the keypad will emit a long beep
and resume idle mode. Just prior to the beep the Zone lights will display the
type of error that was detected:
Light ON Error type
1 key pressed.
2 No matching code was found.
3 Keypad timeout has occurred.
4 Illegal key in current mode.
5 Illegal mode (either system is ON or not in exit delay).
6 Action prevented by a programming option.
7 Address/Action is illegal for this code.