Poulan Pro PR625P_115587827 LAWN TRACTOR - Manual (Page 9)

28
Belt
Drive
cover
PUSH
DOWN
Belt
keeper
Belt
Drive
cover
PUSH
DOWN
Pulley
3 POSITION “QUICK” HANDLES
The handle on your lawn mower has three
(3) height positions - adjust to height that
suits you.
• Squeeze the bottom ends of lower
handle towards each other until the pin
in handle can be inserted into one of the
three height adjustment holes.
High
Handle
adjustment
bracket
Handle pin
Medium
Low
SQUEEZE
TO REMOVE / REPLACE DRIVE BELT
FRONT WHEEL DRIVE MODELS:
“STANDARD” OR “DUAL BAIL” MODELS:
• Remove drive cover. Remove belt from
gearcase pulley by pushing down on
pulley and rolling belt off it.
• Turn lawn mower on its side. See
engine manual for proper direction of
turning over the engine.
• Remove blade.
• Remove belt from engine pulley on
crankshaft.
• Install new belt by reversing above steps.
NOTE: Always use factory approved belt
to assure fi t and long life.
“AUTO WALK” or “VARI-SPEED” MODELS:
• Remove drive cover and belt keeper.
• Remove belt from gearcase pulley by push-
ing down on pulley and rolling belt off it.
• Turn lawn mower on its side. See
engine manual for proper direction of
turning over the engine.
• Remove blade and debris shield.
• Remove belt from engine pulley on
crankshaft.
• Install new belt by reversing above
steps.
NOTE: Always use factory approved belt
to assure fi t and long life.
SERVICE AND ADJUSTMENTS
“QUICK RELEASE” HANDLES
The upper handle may be adjusted to
three (3) different height positions.
1. Loosen both handle levers enough to
allow the upper handle to pivot to the
desired adjustment position.
2. Tighten both handle levers securely.
LEVERS
DOWN
TO ADJUST
HANDLE
Handle
levers
9
TO PRE PARE BATTERY
(ELECTRIC START MODELS ONLY)
NOTE: Your battery must be charged
before you can start your lawn mower.
• Open battery box (if equipped).
• Disconnect engine connector (male)
(if equipped) from battery con nec tor
(female).
• Con nect battery charger con nec tor
(male) to harness con nec tor (fe male).
• Plug battery charger into 110 volt A.C.
outlet.
• Leave battery charger connected for 24
hours before starting your engine for the
fi rst time.
• Reconnect engine connector (male) (if
equipped) to battery con nec tor (female).
• After charging, connect engine con nec tor
(male) (if equipped) to bat tery connector
(female).
Connect your battery charger to charge
battery after each use.
IMPORTANT: The engine will not recharge
your battery.
At the end of the mowing season the
battery should be charged for 48 hours to
protect the battery during winter storage.
CAUTION: Always dis con nect the
en gine connector from the battery con-
nector to prevent ac ci den tal start ing when
trans port ing or stor ing your lawn mower
after the season.
DECK-MOUNTED BATTERY
Engine
connector
(male) Harness
connector
(female)
Battery
charger
Charger
connector (male)
HANDLE-MOUNTED KEY SWITCH
Engine connector (male)
Harness
connector
(female)
Battery charger
Charger
connector
(male)
Battery
box
ASSEMBLY
Engine battery
connector (male) Battery
charger
Charger
connector
(male)
Battery connector (female)
Harness
connector
(female)
Battery charger
Charger
connector
(male)
Battery
box
22PLUS FRONT WHEEL DRIVE
22PLUS REAR WHEEL DRIVE