Poulan Pro PR625P_115587827 LAWN TRACTOR - Manual (Page 11)

26
MAINTENANCE
CLEAN UNDER DRIVE COVER
Clean under the drive cover at least twice
a season. Scrape underside of cover with
a putty knife or similar tool to remove any
buildup of trash or grass.
WATER WASHOUT FEATURE
(IF EQUIPPED)
Your lawn mower may be equipped with a
fi tting that allows quick and easy cleaning
of the underside of the housing. To use
this feature, proceed as follows:
1. Move lawn mower to an area of cut
grass or another hard surface.
NOTE: Water, grass and other debris will
drain from beneath the mower housing
during the washout process.
2. Remove grass catcher and discharge
chute assembly from lawn mower.
3. Close mulcher door (if equipped).
4. Connect a garden hose to the fi tting
where shown.
IMPORTANT: Be sure the garden hose is
not routed under the lawn mower housing
or entangled in the wheels.
5. Turn on water supply and check for
leaks at the fi tting.
If no leaks are present, start engine (as
described in the Operation section of this
manual) and let engine run until the under-
side of the lawn mower is clean.
WARNING: Do not engage the drive
system during the washout process.
6. Shut off the engine.
7. Shut off water supply and remove hose
from fi tting.
CAUTION: Do not remove hose from
fi tting while engine is running. Water in
engine can result in shortened engine life.
8. Start engine (as described in the Op-
eration section of this manual) and let
engine run for a full minute to remove
excess water from mower.
Hose
Fitting
GRASS CATCHER (IF EQUIPPED)
Grass catcher may be hosed with water
but must be dry when used.
CAUTION: Under nor mal usage, the
catch er material is subject to de te ri o ra tion
and wear and should therefore be checked
to ensure compliance with origi nal
manufacturer specifi cations.
11
OPERATION
"QUICK-PIN" ADJUSTMENT
• To change cutting height, pull up on
adjuster lever, move wheel up or down
to suit your re quire ments and release
adjuster lever. Be sure all wheels are in
the same setting.
NOTE: Adjuster is properly positioned
when lever inserts into hole in plate.
LEVER BACKWARD
TO LOWER MOWER
LEVER
FORWARD
TO RAISE MOWER
Plate
Lever
“SINGLE POINT” ADJUSTMENT
• Pull adjuster lever toward wheel. To
raise mower, move lever forward to
desired position. To lower mow er, move
the lever toward the rear.
LEVER
BACKWARD
TO LOWER
MOWER
LEVER
FORWARD
TO RAISE
MOWER
Height
adjuster lever
“DUAL POINT” ADJUSTMENT
Both front wheels are adjusted by a single
lever on the left front wheel. Likewise,
both rear wheels are adjusted by a single
lever on the left rear wheel.
• Pull adjuster lever toward wheel. To
raise mower, move lever forward to
desired position. To lower mow er, move
the lever toward the rear.
Be sure to adjust both front and rear
wheels to the same height.
LEVER BACKWARD
TO LOWER MOWER
LEVER FORWARD
TO RAISE MOWER
Height adjuster lever