Perma Pure Mini-GASS - Manual (Page 15)

15
Mini-GASS User Manual | Original Instructions
PERMA PURE LLC
Mini-GASS™ User’s Manual
Doc. #212: Revision: 00A
Page 15 of 32
6. Place new element in groove in bottom piece. Be sure that element is seated correctly
and parallel to glass shell.
7. Carefully mate bottom assembly onto top piece. Slight twisting motion may be required
to allow shell to slip over o-ring seal.
8. Visually make sure element is seated correctly in top groove.
9. Replace bolt through hole in bottom piece and screw clockwise into top piece. Do not
over-tighten center bolt. It should be just tight enough so it does not vibrate loose.
Over-tightening will not help the filter to seal.
Figure 7 – Filter Element Replacement
Dryers
Under normal conditions, Perma Pure dryers require little maintenance and can last for
several years. However, if there is no pre-filter and the tubing becomes clogged or
saturated with water, the dryer may require cleaning or repair. When disassembling the
dryer, note that the end fittings on the PD-SERIES dryer can be easily rotated on the shell
tube. This rotation should be avoided to prevent twisting the membrane tubes inside the
shell.
Refer to Appendix B for PD dryer element replacement.
Ammonia Scrubber
Media Replacement: When deposits are visible on 75% of the scrubber, scrubbing media
needs to be replaced.
1. Unscrew thumbscrew on bottom of housing.
2. Swing yoke to one side.