Pach and Company AeGIS 4000_4000RT Manual - Manual (Page 17)

CHAPTER 3. PROGRAMMING CHAPTER 3. PROGRAMMING
The AeGIS 4000 can be programmed Local (using built-in keypad), Premise Phone or Remote Phone. Premise phone
programming can only be used if the existing Central Office Line is connected to the system as shown in figure 2.1.
Pach and Company Page 8
AeGIS 4000 Chapter 3. Programming
Local Programming Premise Phone Remote Phone Keys
Press this key once to exit from the
programming mode, you may need to
press the key twice to exit if you
already in the select function mode
Press this key
• once to accept program.
These keys is used to Reset the
Master Code to factory default.
Step 1 Open the panel and turn the
power switch to OFF, see
figure 2.1 to locate the power switch.
Step 2 Press and hold ∗ and # key
simultaneously and turn the system’s
power “On” (switch to the left). You will
hear “Two Short
Beeps” then
“Three Short Beeps” then release the
∗ and #. Your master code is now
0000.
Press this key
• Twice to initiate the call to the
AeGIS 4000, see function code
98 (must be selected to use * ).
• Twice to disconnect the call with
the AeGIS 4000.
Press this key
• Twice to initiate the call to the
AeGIS 4000, see function code
98 (must be selected to use #).
• Once to Extend the talk time for
another cycle.
• Once to accept program.
Press this key twice to disconnect the
call with the AeGIS 4000.
Press this key once to accept
program.
*
#
* and #
RESET MASTER
CODE
Master Code cannot be replaced using
the premise phone. Master Code cannot be replaced using
the remote phone.
00
CHANGE UNIT
MASTER CODE
The default system Master Code
(0000) must be changed for security
purposes. The Master Code is always
4-digit long.
Step 1 Entering The Programming
Mode: Press 0 and # simultaneously
then release. If you are in the
programming mode, proceed to step 2.
Step 2 Enter the 4-digit Master
Code (factory default is 0000) and you
will hear “One Short Beep”. If you
entered an invalid master code you will
hear “One
Long Beep”, repeat
step 1. Should your master code
become lost or forgotten see Reset
Master Code.
Function Local Programming Premise Phone Remote Phone