Pach and Company AeGIS NPB7000 Series Manual - Manual (Page 12)

AeGISNPB7000P Page 12
Checking your installation
1. Turn the “Power” On, the display will go into cycle mode as show
2. Check for the tone on the keypad buttons 0-9, # and *
3. Clear the memory.
4. Adjust the speaker volume, press # wait for dial tone, clockwise-decrease, counter clockwise-increase
refer to figure 2.1
5. Adjust the display intensity refer to figure 2.1
LCD DISPLAY OK FLASH OK DTMF OK
INIT START COMPLETE . . . Welcome to Pach’s
WARNING: IF THE DISPLAY SHOWS BLANK SCREEN, TURN THE SYSTEM IMMEDIATELY
REFER TO FUNCTION CODE 50 TO CLEAR SYSTEM’S MEMORY