Not available on newer system not available – Pach and Company AeGIS 7000 Series Manual User Manual
Page 24
this function will be
disabled
76
TURN ON OR OFF
SPEAKER BEEP
(Default setting is
ON)
If ON, the system beep if
the door is unlocked.
If OFF, the system does
not beep if the door is
unlocked.
77
ENABLE REMOTE
ACCESS
(NOT APPLICABLE ON
NEWER SYSTEM)
(Default setting is
Enabled)
If Enable, the system will
unlock the door if 9 is
pressed.
If Disable, the system will
not unlock the door if 9 is
pressed.
78
VIEW DIRECTORY
BY NAME
This Function Code is very
useful to find the tenant
directory.
Step4
Press
*
then proceed to step 2 and select the
same Function Code or different Function Code
to continue programming or press
*
to exit the
programming mode and you will hear “Three
Short Beeps”.
Step 1
Log on to programming mode (see section 3.1),
the display shows:
Step 2
Enter Function Code 76 then press #, the
display shows:
Step 3
Enter 1 to turn ON unlock beep or 0 to turn
OFF unlock beep, then press #.
Step4
Press
*
then proceed to step 2 and select the
same Function Code or different Function Code
to continue programming or press
*
to exit the
programming mode and you will hear “Three
Short Beeps”.
Step 1
Log on to programming mode (see section 3.1),
the display shows:
Step 2
Enter Function Code 77 then press #, the
display shows:
Step 3
Enter 1 to Enable remote access or 0 to dis
able remote access, then press #.
Step4
Press
*
then proceed to step 2 and select the
same Function Code or different Function Code
to continue programming or press
*
to exit the
programming mode and you will hear “Three
Short Beeps”.
Step 1
Log on to programming mode (see section 3.1),
the display shows:
Step 2
Enter Function Code 78 then press #, and the
name in alphabetical order shows on the display
(press 3 to scroll A-Z or 6 to scroll Z-A).
Step 3
Press # to display the directory code.
Step 4
Select another Function Code to
program another parameter or
tenant's directory, otherwise enter
91 then press # to disconnect the
call, you hear “Three Short
Beeps”.
Step 1
Log on to programming mode,
see section 3.2 If you have
logged on proceed to step 2.
Step 2
Enter Function Code 76 then
press #, you hear “One Short
Beep”.
Step 3
Enter 1 to turn ON unlock beep
or 0 to turn OFF unlock beep,
then press # and you will hear “
Two Short Beeps”.
Step 4
Select another Function Code
to program another parameter or
tenant's directory, otherwise enter
91 then press # to disconnect the
call, you hear “Three Short
Beeps”.
NOT AVAILABLE ON NEWER
SYSTEM
NOT AVAILABLE.
FUNCTION CODE
LOCAL PROGRAMMING
TOUCH TONE PROGRAMMING
Pach and Company
Chapter 3
Page 17
AeGIS 7000 Series
PROGRAMMING
Select Func: _ _
UnlockBeep (1,0): 1
Select Func: _ _
ENA=1 DISA=0: 1
Select Func: _ _