Pach and Company AeGIS 7000 Series Manual - Manual (Page 21)

46
SYSTEM
INFORMATION
Display the model number
and the firmware released
date.
50
CLEAR THE
MEMORY TO
FACTORY
DEFAULT
Use this Function Code will
erase the whole database
and and reset the system
to factory default.
Step 4 Press * to erase the 2nd segment then enter
the welcome message then press # # to proceed
to the 3rd segment, the display shows:
Step 5 Press * to erase the 3rd segment then enter
the welcome message then press # #.
Step 6 Proceed to step 2 and select the same Function
Code or different Function Code to continue
programming or press * to exit the programming
mode and you will hear “Three Short Beeps”.
Note: See keypad correlation on page 3.
Step 1 Log on to programming mode (see section 3.1),
the display shows:
Step 2 Enter Function Code 46 then press #, the
display shows:
XXX: the model number.
MM/DD/YY: month, date, and year firmware
released.
Step3 Press * then proceed to step 2 and select the
same Function Code or different Function Code
to continue programming or press * to exit the
programming mode and you will hear “Three
Short Beeps”.
Step 1 Log on to programming mode (see section 3.1),
the display shows:
Step 2 Enter Function Code 50 then press #, the
display shows:
Step 3 Press 1 to confirm the display shows:
and the system returns to Welcome Screen,
or * to cancel and proceed to step 3.
Step4 Press * then proceed to step 2 and select the
same Function Code or different Function Code
NOT AVAILABLE.
NOT AVAILABLE.
FUNCTION CODE LOCAL PROGRAMMING TOUCH TONE PROGRAMMING
Pach and Company Chapter 3 Page 14
AeGIS 7000 Series PROGRAMMING
ss System . . . * *
Select Func: _ _
V7XXX MM/DD/YY
Select Func: _ _
1 to confirm: _
DB Init. Wait . . . _