Pach and Company AeGIS 9000P Series Manual - Manual (Page 33)

FUNCTION CODE LOCAL PROGRAMMING
46
DISPLAY SYSTEM INFORMATION
50
CLEAR THE EEPROM MEMORY
TO FACTORY DEFAULT
51-60
Wiegand Facility Code
Step 5 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 46 then press # and the display shows
XXXX= a maximum number of tenants
YYYY= a maximum number of keypad access code and card.
MM.DD.YYYY= Month. Date. Year the Firmware is released.
Then the display shows
Step 3 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 50 then press # and the display shows
Step 3 Enter 1=TO CLEAR or 0=TO CANCEL then press #, the display shows
Step 4 Wait for a few minutes, the more tenants programmed the longer it takes to
erase the memory the the display shows
Step 5 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Facility code 3-12. See function code 25-26 to program on page 21. 12 different
facility code can be programmed on AeGIS 9000P firmware version May 24, 2011 or
later
Pach and Company Chapter 3 Page 28
AeGIS 9000P Series PROGRAMMING
SELECT PROGRAM
ENTER: _ _ PRESS #
V ER AXXXRYYYY
MM.DD.YYYY CR
SELECT PROGRAM
ENTER: _ _ PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
0/1 CLR eeprom . . .
N/Y:0 # ENT * EX
INITIALIZATION . .
EEPROM Testing . .
Welcome to Pach’s Telep
Press 3 for Dir .