Pach and Company AeGIS 9000P Series Manual - Manual (Page 18)

Pach and Company Chapter 3 Page 13
AeGIS 9000P Series PROGRAMMING
FUNCTION CODE LOCAL PROGRAMMING
Step 3 Enter 16 -characters on the first segment by rewriting the existing
message or pressing * to clear the segment and reenter the message, see
keypad correlation on figure 3.1, press # on every character you have
entered and press ## after the last character you have entered on each
segment, then the display shows
Step 4 Enter 16 -characters on the second segment, by rewriting the existing
message or pressing * to clear the segment and reenter the message, press
# on every character you have entered and press ## after the last character
you have entered on each segment, then the display shows
Step 5 Enter 16 -characters on the third segment, by rewriting the existing
message or pressing * to clear the segment and reenter the message, press
# on every character you have entered and press ## after the last character
you have entered on each segment, then the display shows
Step 6 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Press Once
Press Twice
Press Three Times
FIGURE 3.1
s Telephone Acce
MESSAGE SEGMENT 2
ss Control . . . .
MESSAGE SEGMENT 3
SELECT PROGRAM
ENTER: _ _ PRESS #
NOTE: IF YOU INTEND TO LEAVE THE WELCOME SCREEN BLANK
PRESS * THEN PRESS ## ON EVERY SEGMENT.
Press 0 for space (move
cursor to the right.
Press 8 then 0 for back
space (move cursor to
left)
Press * to clear all
letters or numbers
entered