Pach and Company AeGIS 9000P Series Manual User Manual

Page 16

FUNCTION CODE

LOCAL PROGRAMMING

SYSTEM ID

(Default setting is 0)

REMOTE ENABLE/DISABLE

(Default setting is Enabled)

Set the function code to ENABLE if

the management software is used to

program the system. If the function

code is set to DISABLE, the system

will not answer an incoming call.

RELAY 2 MODE

(Default setting is as DOOR.

CONTROL)

MODE1: DOOR CONTROL

MODE 2: A SHUNT

MODE 3: AN ALARM TIMER

MODE 4: A CCTV SWITCH

See Chapter 4. System’s

Operation for more detail

explanation.

Step 4

Select another Function Code to program different field from the table or
press * to exit the programming mode.

Do not change the programming, leave the value as default. The function code is
not used.

Step 1

Log on to programming mode (see section 3.1). The display shows

Step 2

Enter Function Code 07 then press # and the display shows

Step 3

Enter 1 to ENABLE and 0 to DISABLE then press #, the display shows

Step 4

Select another Function Code to program different field from the table or
press * to exit the programming mode.

Step 1

Log on to programming mode (see section 3.1). The display shows

Step 2

Enter Function Code 08 then press # and the display shows

Step 3

Enter 1- DOOR CONTROL

2- A SHUNT
3- AN ALARM TIMER
4- A CCTV SWITCH

then press #, the display shows

Step 4

Select another Function Code to program different field from the table or
press * to exit the programming mode.

Pach and Company

Chapter 3

Page 11

AeGIS 9000P Series

PROGRAMMING

SELECT PROGRAM
ENTER: _ _ PRESS #

REMOTE YES=1 NO=0
ENTER: 1 PRESS #

SELECT PROGRAM
ENTER: _ _ PRESS #

RELAY 2 MODE (1-4)
ENTER: 1 PRESS #

SELECT PROGRAM
ENTER: _ _ PRESS #