Warning – Pach and Company AeGIS 9000P Series Manual User Manual
Page 31
FUNCTION CODE
LOCAL PROGRAMMING
40
MASTER CODE MASK
(Default setting is disabled)
WARNING !!!!!!!!
• Master Code cannot be recovered
if Master Code Mask is enabled. You
must replace the board.
41
OPEN DOOR BEEP
(Default setting is enabled)
• The system will beep if relay or
relay 1 (door 1) or relay 2 (door 2) is
unlocked.
42
ENABLE OR DISABLE PBX
(Default setting is disabled)
• This function must be enabled and
programmed to dial an outside line
from the PBX.
• If the function is enabled and the
PBX dial out number is programmed,
the system will provide a second
pause before it dials the phone
number
Step 5
Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1
Log on to programming mode (see section 3.1). The display shows
Step 2
Enter Function Code 40 then press # and the display shows
Step 3
Enter 0=NO or 1=YES then press # the display shows
Step 4
Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1
Log on to programming mode (see section 3.1). The display shows
Step 2
Enter Function Code 41 then press # and the display shows
Step 3
Enter 0=NO or 1=YES then press # the display shows
Step 4
Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1
Log on to programming mode (see section 3.1). The display shows
Step 2
Enter Function Code 42 then press # and the display shows
Step 3
Enter 0=NO or 1=YES then press #, the display shows
Pach and Company
Chapter 3
Page 26
AeGIS 9000P Series
PROGRAMMING
SELECT PROGRAM
ENTER: _ _ PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
MC DISPLAY MASK
0=NO 1=YES : 0
SELECT PROGRAM
ENTER: _ _ PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
Open Door Beep
0=NO 1=YES : 1
SELECT PROGRAM
ENTER: _ _ PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
PBX Subscriber
0=NO 1=YES