Nitek FRS581000R00 - Manual (Page 2)

Power Requirements
Power (Stand Alone) 12VDC to 18VDC / 600mA maximum
(Rack Card) Provided from FRS1000 Card Rack
Video Input Connections
Connector 75 ohm BNC socket
Input Impedance 75 ohm terminated
Input Level 1 volt p-p nominal
Frequency Response 10Hz to 5.75MHz
Fiber Connections
Primary OPTO Out
Connector LC/PC
Primary Optical Out Power -5dBm
Wavelength 1310nm
Optical Fiber Single-Mode
Primary OPTO In
Connector
LC/PC
Primary Optical Sensitivity -22dBm
Wavelength 1310nm
Optical Fiber Single-Mode
Data LEDs
Channel A Data (if equipped)
Data Present TX
Green—data high
(RS485/RS422) Red—data zero
Off—tri-state or N/C
Data Present TX
(RS232) Green—data
high
Red—logic transitions
Off—data zero
Channel B Data (if equipped)
Data Present TX
Green—data high
Red—logic transitions
Off—data zero
Channel B Audio Data (if equipped)
Audio Present TX
Green—audio > -40dBm
Red—audio > 0dBm
(audio overload level+6dBm)
Off—audio < -40dBm
Front Panel Indicators
Opto LEDs
Primary
Opto Green—transmitting
Off—not transmitting
Secondary Opto
Green—transmitting
(if equipped) Off—not transmitting
Video LEDs
Video
Present Green—video present
Safety
The 5000 series of products uses a Class 1 laser system in accordance with IEC 60825-2.
It is always advisable to follow good practice when working with optical fiber systems. This includes:
•
Do not stare with unprotected eyes at fiber ends or connector faces.
• Use only approved filtered or attenuating viewing devices.
• For other safety issues and advice on good practices associated with optical fiber systems see IEC 60825-2
or your local safety officer.