NetMedia VIDLAMP-HIR - Manual (Page 2)

MAN-VIDLAMP-HIR REV0707A
NM-VIDL
AMP-HIR
NM-VIDLAMP-HIR (SCE3-IR)
NetMedia, Inc., 10940 N. Stallard Place, Tucson, Arizona 85737 (520) 544-4567 Fax: (520) 544-0800 Email: [email protected] www.netmedia.com
DO NOT CUT OR SPLICE THE CAMERA’S CABLES. MODIFYING THE UNIT IN ANY WAY WILL VOID THE WARRANTY.
Installation Procedures:
1. Ensure that the camera is grounded with the ground strap as shown in the FCC Information.
2. Connect a grounded video cable from the viewing device (monitor, Quad, DVR, modulator, etc.) to the camera’s
Video Connector. Adapters, such as BNC to F or RCA, may be used where appropriate.
3. Connect the 12V DC 300mA Power Transformer from an AC outlet to the camera’s Power Input Connector.
4. Mount the base to the junction box (not included) and adjust the camera assembly for proper viewing. When
satisfied, secure all adjustment points.
Camera
Figure 3 - Connecting the camera to a modulator for whole house distribution and standard television viewing on
the modulated channel. The modulator can also be the last piece of equipment in Figure 2.
AMP
Main cable or
antenna
Modulator
Amplifier
Television
Television
Figure 2 - Connecting the camera to multiple pieces of video equipment. Every piece except the last must have a
loopback or video output jack.
Camera
Monitor
or
Television
Quad.
Sequencer
or
DVR
To Next
Device
Figure 1 - Connecting the camera to a security monitor or standard television. Use the TV’s composite RCA Video In
jack and view through its video or line input. The picture will not be available on a channel.
Camera
Video Cable
Monitor
or
Television
Distribution
Panel
or Splitter
Splitter/
Combiner