NetMedia POCLAMP-DI - Manual (Page 2)

MAN-POCLAMP REV1002A
NM-POCL
AMP
NM-POCLAMP
NetMedia, Inc., 10940 N. Stallard Place, Tucson, Arizona 85737 (520) 544-4567 Fax: (520) 544-0800 Email: [email protected] www.netmedia.com
Coax Cable
Figure 3 - Connecting the camera to a modulator for whole house distribution and standard television viewing on
the modulated channel. The modulator can also be the last piece of equipment in Figure 2.
AMP
Main cable or
antenna
Modulator
Amplifier
Television
Television
PoC Video Decoder Module
Distribution
Panel
or Splitter
Splitter/
Combiner
Camera
Coax Cable
Figure 2 - Connecting the camera to multiple pieces of video equipment. Every piece except the last must have a
loopback or video output jack.
Monitor
or
Television
Quad.
Sequencer
or
DVR
To Next
Device
PoC Video Decoder Module
Camera
Installation Procedures:
1. Connect a coax cable (RG6 recommended) to the F-connectors of the camera and Video Decoder. Each
Camera/Decoder pair needs a dedicated point-to-point wiring circuit. Do not connect the Camera/Decoder coax to
video distribution equipment! Doing so could damage this product and/or the other attached devices!
2. Connect a video cable from the viewing device (monitor, Quad, DVR, modulator, etc.) to the Decoder’s RCA Video Out
Connector. Simple adapters, such as RCA to BNC, may be used where appropriate.
3. Connect the 24V DC 200mA Power Transformer from an AC outlet to the Decoder’s Power Input Connector.
4. Mount the Base to the junction box (not included) and adjust the camera assembly for proper viewing. When
satisfied, secure all adjustment points.
DO NOT CUT OR SPLICE THE CAMERA’S CABLES. MODIFYING THE UNIT IN ANY WAY WILL VOID THE WARRANTY.
Figure 1 - Connecting the camera to a security monitor or standard television. Use the TV’s composite RCA Video In
jack and view through its video or line input. The picture will not be available on a channel.
Camera
Video Cable Coax Cable
Monitor
or
Television PoC Video Decoder Module
Up to 100 Feet