DoorKing 1819 Information Phone - Manual (Page 24)

1819-065-B-4-07
3.1.7 System to Stay On-Line or Hang Up after Touch Tone
This programming sequence provides a method for the telephone entry system to remain on line after
a resident has pressed the touch tone number to open the door or gate.
Factory setting = 1 (hang up after touch tone).
1. Press *28 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Press 1* (beep).
3. Press 0* (beep) to keep the system on line, or press 1* (beep) to make it hang up.
4. Press 0# TOGETHER to end this programming step (beeeeeep).
3.1.8 Automatic Hang-up Function
This programming sequence determines when the phone system will automatically hang itself up
after a predetermined time of inactivity. You can program the system to not hang-up (0), to hang-up
after 5 sec of dial-tone (1), to hang-up after 15 sec of silence (2) or to hang-up after either 5 sec of
dial-tone or 15 sec of silence (3). NOTE: This programming function is available on REV G
boards or higher only.
Factory setting = 1 (hang-up after 5 sec of dial-tone).
1. Press *40 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the hang-up code desired _ then press * (beep).
3. Press 0# TOGETHER to end this programming step (beeeeeep).
Code Function
0 No hang-up.
1 Hang-up after 5 sec. of dial-tone (Factory setting).
2 Hang-up after 15 sec. of silence.
3 Hang-up after 5 sec. of dial-tone OR 15 sec. of silence.
3.1.9 Call Button to Dial Out
This programming sequence sets the CALL button to dial the phone number programmed in 3.2.1.
1. Press *23 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter 2* (beep).
3. Enter 1* (beep).
4. Press 0# TOGETHER to end this programming step (beeeeeep).
Page 24