Detroit Radiant Products Company LS3 Series - Manual (Page 60)

60
LS3 Series 5.0 Maintenance • Kit Contents Check List
Kit Contents Check List
Chart 5.2 • Kit Contents for LS3 Series - Reference the length column for your model.
Printed in U. S. A.
Approvals
• ANSI Z83.20 and CSA 2.34.
• Indoor approval.
• Certain models are residentially
Certified to CSA No. 7-89.
• Outdoor approval with OD-Kit.
• Commercial approval.
Limited Warranty
• 1 year - Burner box components.
• 3 years - Combustion and radiant tubes.
• 5 years - Stainless steel burner.
• See page 58 for terms and conditions.
© 2014 Detroit Radiant Products Co.
21400 Hoover Road • Warren, MI 48089
Phone: (586) 756-0950 Fax: (586) 756-2626
www.detroitradiant.com • [email protected]
Part No. Description
LS3
10-25
LS3
10-30
LS3
15-25
LS3
15-30
LS3
15-40
LS3
15-50
LS3
20-40
LS3
20-50
LS3
30-50
TP-19B 4" Hanger w/ Tension Spring 1 1 1 1 1 2 1 2 2
TP-21B 4" Tube Clamp 0 0 0 0 0 1 0 1 1
TP-33B 1/2” Shut-Off Valve & Inlet Tap 1 1 1 1 1 1 1 1 1
TP-82 4" Reflector Center Support (RCS) 0 0 0 0 0 1 0 1 1
TP-83 24" S.S. Flexible Gas Connector 1 1 1 1 1 1 1 1 1
TP-105 Reflector End Cap 2 2 2 2 2 2 2 2 2
TP-106 Reflector End Cap Clips 8 8 8 8 8 8 8 8 8
TP-220 4" Stainless Steel Tube Clamp 1 1 1 1 1 1 1 1 1
TP-1077 3" Tube Clamp 0 0 1 1 1 0 1 0 1
TP-1078 3" Reflector Center Support (RCS) 1 1 1 1 1 0 1 1 2
TP-1079 3" Hanger w/ Tension Spring 1 1 2 2 2 1 2 1 2
LIOLS3 LS3 Series Installation Manual 1 1 1 1 1 1 1 1 1
Filled By:
WARNING !
Improper installation, adjustment, alteration, service or maintenance can cause
property damage, injury or death. Read the installation, operation and maintenance
instructions thoroughly before installing or servicing this equipment.
This heater
must be installed and serviced by trained gas installation and service personnel only. Failure to comply could result in personal injury, asphyxiation, death,
fire or property damage.
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of
this or any other appliance.
In locations used for the storage of combustible materials, signs
must be posted to specify the maximum permissible stacking height to maintain the required clearances
from the heater to the combustibles. Signs must either be posted adjacent to the
heater thermostats or in the absence of such thermostats, in a conspicuous location.
Do not use this heater in indoor living or sleeping quarters, etc.! Installation of
a tube heater system in residential indoor living spaces may result in property damage,
serious injury, asphyxiation or death.
LS3 Series
Installation Manual
The LS3 Series Infrared Tube Heater is a positive pressure, single-stage radiant heater system. This
manual provides specific information related to the LS3 Series model. All persons involved with the
installation, operation and maintenance of the heater system must read and understand the information
in this manual.
For Your Safety
If you smell gas:
• Do not try to light any appliance. • Immediately call your gas supplier from a neighbor’s phone. • Do not touch any electrical switch. • Follow the gas supplier’s instructions. • Do not use any phone in your building. • If you cannot reach your gas supplier, call the fire department.
LIOLS3-Rev. 32513 Print: 1M-12/13 (CDS)
INSTALLER: Present this manual to the end user. Keep these instructions in a clean and dry place for future reference. Model#: ___________________ Serial #: _________________________ (located on rating label)
TP-82 4” RCS
TP-19B 4” Hanger with
Reflector Tension Spring
TP-105 Reflector End Cap
TP-220 4” Stainless Steel
Tube Clamp
TP-106 Reflector
End Cap Clips
LS3 Series Kit Contents
LS3 Series Installation,
Operation and
Maintenance Manual
F/N: LIOLS3
TP-1078 3” Reflector
Center Support (RCS)
TP-1079 3” Hanger with
Reflector Tension Spring
TP-21B 4” Tube Clamp
TP-1077 3” Tube Clamp
TP-83 24” Stainless Steel
Flexible Gas Connector
TP-33B 1/2” Shut-Off Valve
(Ball Valve & Inlet Tap)