Detroit Radiant Products Company QTD Series - Manual (Page 3)

1.0 Introduction
QTD Series
3
Overview
The intent of this manual is to provide information regarding general safety, installation, operation and
maintenance of this radiant tube heater. You must read and understand all instructions and safety
warnings before installing or servicing the radiant tube heater.
Heater Components
Prior to installation, verify that the heater’s gas type and voltage (as listed on the rating plate) match
that of your application. Also verify that you have received all heater components included with your
radiant tube heater. Refer to page 44 for a list of the kit contents for your Series heater. Materials not
included in the heater kit contents (e.g., screws, vent material, terminals, etc.) are the responsibility of
the installer. Notify your product representative or Detroit Radiant Products of any discrepancy or
missing kit contents prior to installing unit.
Specifications
Chart 1.1 • QTD Series Specifications
* Input at full rate.
** Recommended mounting heights are provided as a guideline. Actual conditions may dictate variations from
this data.
Shipping / Boxing:
B = Burner Control Box (45#) & (31.5”L x 17.5”W x 15.5”H)
T = Emitter Assembly and Reflector Box (88#) & (91”L x 31”W x 14”H)
NOTE: See Kit Contents on page 44.
1.0 Introduction • Overview • Heater Components • Specifications
Model
Number Gas Type
BTU/h
Low Fire*
BTU/h
High Fire*
Recommended
Mounting Heights** Unit Weight
Overall Unit
Length
QTD-60N Natural Gas 40,000 60,000 8 to 12 ft. 103 lbs. 103”
QTD-60P Propane 40,000 60,000 8 to 12 ft. 103 lbs. 103”
QTD-80N Natural Gas 50,000 80,000 10 to 14 ft. 103 lbs. 103”
QTD-80P Propane 50,000 80,000 10 to 14 ft. 103 lbs. 103”