Multichannel Systems STG1000 Manual - Manual (Page 13)

First Use of the Stimulus Generator
7
3.3 Installing the Software
System requirements
Software: One of the following Windows © operating systems is required: Windows 2000 or
Windows XP (English and German versions supported). Other language versions may lead to
software errors.
Hardware: RS232 serial port
Installing the software
Please check the system requirements before you install the software. MCS cannot guarantee that
the software works properly if these requirements are not fulfilled.
Important: Please make sure that you have full control over your computer as an administrator .
Otherwise, is possible that the installed software does not work properly.
1. Double-click Setup.exe on the installation volume.
The installation assistant will show up and guide you through the installation procedure.
2. Follow the instructions of the installation assistant. Please select the appropriate maximum
number of analog output channels according to the connected STG. If you have different STGs in
use, choose the highest number.
When you have finished the installation of the MC_Stimulus software, you can now operate the
STG.