Multichannel Systems STG1000 Manual - Manual (Page 10)

Stimulus Generator 1000 Series User Manual
4
The product has been built to the state of the art and in accordance with recognized safety
engineering rules. The device may only
• be used for its intended purpose;
• be used when in a perfect condition.
• Improper use could lead to serious, even fatal injuries to the user or third parties and damage to
the device itself or other material damage.
Warning: The device and the software are not intended for medical uses and must not be used
on humans.
Malfunctions which could impair safety should be rectified immediately.
High Voltage
Electrical cords must be properly laid and installed. The length and quality of the cords must be in
accordance with local provisions.
Only qualified technicians may work on the electrical system. It is essential that the accident
prevention regulations and those of the employers' liability associations are observed.
• Each time before starting up, make sure that the mains supply agrees with the specifications of
the product.
• Check the power cord for damage each time the site is changed. Damaged power cords should
be replaced immediately and may never be reused.
• Check the leads for damage. Damaged leads should be replaced immediately and may never be
reused.
• Do not try to insert anything sharp or metallic into the vents or the case.
• Liquids may cause short circuits or other damage. Keep the device and the power cords always
dry. Do not handle it with wet hands.
Requirements for the installation
• Make sure that the device is not exposed to direct sunlight. Do not place anything on top of the
device, and do not place it on top of another heat producing device. Otherwise, the device may
overheat.