Aiwa CSD-NS1 - Manual (Page 12)

12
ENGLISH
TIMER OPERATION
D
TIMER PLAYBACK/RECORDING
The unit can be turned on at a specified time every
day with the built-in timer.
Make sure the clock is set correctly.
1
Press TIMER twice for timer play or three
times for timer recording so that “
5” or
“ 5 REC” flashes in the display.
2
Turn VOLUME/TIMER to specify the
timer-on time.
r or t is also available. Holding it down
changes the time in 20-minute units.
3
Press ENTER or a.
4
Turn VOLUME/TIMER to specify the
timer-activated period.
The time changes between 5 and 180 minutes in
5-minute units.
r or t is also available.
5
Press ENTER or a.
6
Prepare the source.
To listen to a CD, press CD and load the disc.
To listen to a tape, press TAPE/REV MODE and
load the tape.
To listen to a radio broadcast, press TUNER/
BAND and tune to the desired station.
To record from a radio broadcast, press
TUNER/BAND and tune to the desired station, and
load the tape to be recorded on.
7
Adjust the volume and tone, then turn off
the unit.
The unit turns on with the selected source at the
specified timer-on time, and turns off after the
specified timer-activated period.
NOTE
• If you use the unit after setting the timer, repeat steps
6 and 7.
• Timer recording is available only when the source is
TUNER.
To check the timer setting
1 Press TIMER twice or three time.
The timer-on time is displayed.
2 Press ENTER.
The timer-activated period is displayed.
3 Press ENTER to restore the display.
To cancel the timer standby mode
Press TIMER repeatedly so that “ 5 ” or “ 5 REC”
disappears.
To reset the timer
Repeat all the steps above.
Timer-on time
r , t
a
TAPE / REV MODE,
TUNER / BAND,
CD
ENTER
VOLUME / TIMER
TIMER
SLEEP